Label Printer Pegboard Shelf, 1/4", Roll Hook Only

¼” Pegboard Shelf Installation Instructions

Thank-you for purchasing our ¼” pegboard compatible shelf! It utilizes a unique anchoring design to ensure robustness.  Make sure your pegboard is securely fastened to the wall prior to shelf installation. Read below for installation instructions.

1. Once you receive your order, you will notice that the two shelf brackets have a bolt through a flexible black tube at the top. *NOTE* brackets are mirror image, they are not interchangeable! Flat side faces inward.
2. Ensure that the nut on the back of the flexible tube is hand snug against the tube.
3. Insert the brackets into your ¼” pegboard. 
4. Use the shelf to ensure proper spacing between the brackets.
5. Remember, flat side faces inward!
6. Using the supplied tool (1.5mm Hex Allen key, though a 1.5mm screwdriver makes it a bit easier), tighten the bolt on the shelf brackets.
7. The nut will stay snug against the tube, there should be no need to reach behind the pegboard.  The nut will compress the black tube, causing the tube to flair out and act as an anchor. 
8. Continue tightening until the bracket is sturdy in the vertical direction. 
9. If you push down on the bracket (push as if the shelf were on the brackets), and a gap appears between the pegboard and the shelf bracket, tighten some more.
10. Place the shelf on top of the brackets, ensuring the bracket pins are seated in the shelf.

Shelf Removal:

1. To remove shelves, loosen the front bolt while gently pulling the bracket away from the pegboard wall.  
2. The flexible backing will have taken the anchor shape permanently, so by pulling 33.0111unscrewing.
3. Once the bracket is removed from the pegboard. You can reinsert in a different location with the existing flexible backing (by gently smushing it in), or with the spares provided.

Thank-you for your business!

Sincerely, Alex and Abby - Owners